bing tracking image
Customer Service My Orders
7 min

Filter Questions and Answers:

reset filter

Expert Answers about Lance TC Truck Camper


  • Replacement Mounting Brackets For HappiJac Electric Truck Camper Jack System
  • If you're looking for just the L-bracket for your HappiJac Electric Truck Camper Jack System # LC736514-ELKIT then you'll need part # LC182492. The flat bracket can be swapped out with part # LC182494 and the swing brackets can be replaced with part # LC182496.
    view full answer...

  • Is It Possible To Upgrade To 5 Step Truck Camper Steps To 2022 Lance 825 Truck Camper?
  • The 5 step TorkLift GlowSteps # TLA7505 could work for your 2022 Lance 825 truck camper, but require that you have an entry height of 38-1/2" to 46" of entry height. This is measured from the bottom of your door to the ground when parked on level ground. This system mounts directly to the body of the camper right below the door so it'll bypass your factory steps, but you need to make sure there's enough structure under the door to secure the steps. If you find you have a different entry...
    view full answer...

  • Can A RoadMaster 6-Wire Trailer Connector Be Used To Replace The 7-Way On A Truck Bed Camper
  • A truck bed camper will typically have a hardwired 7-way cable that plugs into the 7-way socket in your truck. If you were wanting to remove the hardwired cable from the camper and install the RoadMaster 6-Wire Trailer Connector # RM-910030-7 on the camper you could then use a 7-Wire to 6-Wire to connect your camper to the truck. If you'd prefer a bundle of both components then I recommend the Roadmaster 7-Wire to 6-Wire Flexo-Coil Kit # RM-146-7. If your camper setup differs then just...
    view full answer...

  • Recommended Option For Swapping Out A Lance Proprietary 6-Pole Socket
  • The 6-pole sockets that we carry can only handle up to 12 gauge wire so the only way to really swap away from Lance's proprietary connector would be to treat it like a standard camper and switch to a junction box and 7-way connector like parts # 38656 and # H20046. This junction box has ring terminal posts so you could easily use a large gauge wire. You could remove the current socket and mount the junction box next to it and run the wires through the hole where the socket was. You can...
    view full answer...